Top

Ignition Kokusan Replica 50CC 6 Volt

DKK 935.56
In stock, immediately available.
In stock
SKU
276-D-UN18450
  • Electronic Ignition
  • Kokusan Replica
  • 6 Volt
  • Comes with manual / scheme (Dutch)

    Including;
  • Stator / Base plate (Ø 90MM)
  • Flywheel
  • Voltage regulator
  • Coil / CDI-Unit
  • Wiring harness

    Fits a.o:
  • Kreidler 50CC
  • Zundapp 50CC
  • Puch (Linksdraaiende blokken)
  • Tomos (Linksdraaiende blokken)

  • Note: In exceptional cases the base plate must be turned down 1mm to prevent the flywheel from binding.

  • For 24,000 RPM, note here you may need a pulse reducer.
  • For 36,000 RPM

  • Mounting tips:
    - The black wire of the CDI Unit must make a ground/mass connection with the engine block. This can be done directly (preferably) or indirectly via the frame.
    - With Zundapp, among others, the engine doesn't have a ground/mass connection with the frame, because it's mounted in rubbers. Therefore add an additional ground wire between the block and the frame.
    - With ground/mass connections to the frame, the mounting point must always be made bare/blank.
  • Electronic Ignition
  • Kokusan Replica
  • 6 Volt
  • Comes with manual / scheme (Dutch)

    Including;
  • Stator / Base plate (Ø 90MM)
  • Flywheel
  • Voltage regulator
  • Coil / CDI-Unit
  • Wiring harness

    Fits a.o:
  • Kreidler 50CC
  • Zundapp 50CC
  • Puch (Linksdraaiende blokken)
  • Tomos (Linksdraaiende blokken)

  • Note: In exceptional cases the base plate must be turned down 1mm to prevent the flywheel from binding.

  • For 24,000 RPM, note here you may need a pulse reducer.
  • For 36,000 RPM

  • Mounting tips:
    - The black wire of the CDI Unit must make a ground/mass connection with the engine block. This can be done directly (preferably) or indirectly via the frame.
    - With Zundapp, among others, the engine doesn't have a ground/mass connection with the frame, because it's mounted in rubbers. Therefore add an additional ground wire between the block and the frame.
    - With ground/mass connections to the frame, the mounting point must always be made bare/blank.
We found other products you might like!
Reviews
No Reviews
Write Your Own Review
Your Rating
FAQ about this product
No Questions

Do you have a question?

Leave your question below and one of our experts will take care of you as soon as possible.